ATC-800+ dual Aquarium temperature thermost

temperature thermostat ATC-800+

Features:
-An all-in-one package works with both heating and cooling system;
-Control temperature by setting the temperature setting value and the difference value;
-Easy-to-read large LCD display;
-Alarm warning when temperature exceeds measuring range, or sensor open circuit or short circuit
-Built-in short circuit sensor;
-Automatic control for aquariums and other systems that require constant regulation-avoid hassle of monitoring your aquarium environment;
-Temperature calibration;
-Switch the modes between cool and heat
-Refrigerating control output delay protection;
-Alarm when temperature exceeds temperature limit or when sensor error(when the controller sensors open or short circuit ).
-Fully salt water safe probe;
-Easy to install and use;
-Sturdy plastic unit;
-Wiring diagram provided.

Panel instructions
-Three –digit LED
-Minus digit
-“cool/heat” key: status indicator light
-“on/off“ key: running status indicate
-“temp“ key: temperature set indicator light
-Temperature difference set indicator light

Easy to Program and Use:
-Wire the controller to the heating or cooling system that requires regulating;
-Set your required temperature;
-Set the temperature difference (between 1-5°)
-Switch the controller and system on
-Sit back, safe in the knowledge that the micro computer controller will do all the hard work for you

Specification:
-Temperature measuring range: -50°C ~ +99°C
-Relative humidity: 20% ~ 85% (No condensate)
-Resolution: 0.1°C (-19.9~99°C)
-Accuracy: ±1°C (-50°C ~ +70°C)
-Sensor error delay: 1 minute
-Power supply: 220V AC ± 10%  50/60Hz
-Power consumption: <5W
-Sensor: NTC sensor (1 PC)
-Relay contact capacity: Cool (20A/250VAC); Heat (10A/250VAC)
-Ambient temperature: 0°C ~60°C
-Storage temperature: -30°C ~75°C

Dimension:
-Front panel size: 180mm x 100mm (LxW)
-Mounting size: 170mm x 90mm (LxW)
-Product size: 180mm x 100mm x 57mm (LxWxD)
-Cable length: 6.6ft /2 M ( including the probe)
-Weight: 410g

Danger:
-Strictly distinguish the sensor down-lead, power wire and output relay interface from another, and prohibit wrong connections or overloading the relay
-Prohibit connecting the wire terminals without electricity cut off.

Warning:
Prohibit using the machine under the environment of over damp, high temperature, strong electromagnetism interference or strong corrosion.

Note:
-The power supply should conform to the voltage value indicated in the instruction.
-To avoid the interference, the sensor down-lead and power wire should be kept in a distance.
-Please note that the controller will only act as a relay switch for your heater/cooler - it will not supply electric power directly from the terminals.

Related Products